Avmap EKP V User Manual Bedienungsanleitung PDF herunterladen (Seite 5)

Aeronautical Navigator AvMap EKPV

4 - Quick Manual

Aeronautical Navigator AvMap EKPV

Quick Manual - 5

Cartographic data loaded in the EKP V can

differ from reality. The pilot in command

assumes total responsibility and risk

associated with the use of this device and

remains solely responsible for ying in safe

conditions.

AvMap disclaims any liability deriving from

an improper use of the device, in a way that

may violate the ight and navigation rules,

regulations and safety.

IV. Unit setup

1. Open the battery compartment

2. Insert the Micro SD, if not already

inserted

3. Insert the battery

4. Close the battery compartment door

5. Rotate the GPS antenna to the maximum

sky visibility position.

6. Connect EKP V to a power source for

battery charging:

6.1 Connect the cigar lighter cable with

the label face up to the EKP V side

connector, or

6.2 Connect the USB cable to a PC (slow

battery charge), or

6.3 Connect the USB cable to the wall

charger.

7. The unit will automatically switch on.

V. Powering Up the unit

The EKP V can be powered up both running

on battery or on external power.

When running on battery to power up the

unit press once the POWER button. When

the external power cable is connected either

with battery inserted or not inserted the unit

will automatically switch on.

In the power up phase two consecutive splash

screens will appear. After a few seconds

the second splash screen will be replaced

by the Warning page. To move to the map

press the joystick (ENTER). The EKP V has

been conceived to be always ready to use

through a STANDBY functionality which can

be set by the user.

The user can set a time interval from a

minimum value of 5 min to a maximum of

120 min to enable the function.

The user can put the EKP V manually in

STANDBY by pressing the PWR button

and release the PWR button before the

countdown. To turn off the unit completely

the user needs to keep the PWR button

pressed for more then 3 seconds

When the navigator is in STANDBY, pressing

POWER button it is possible to resume the

unit on the map page. It is suggested to not

1 2 3 4 5 6 7 8 9 10 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare